DENSITY, MASS, VOLUME

VOLUME (REGULAR SOLID)

• First you need to measure the length, width, and hight.
• Next multiply the measurements you just found.
• Finally add your label which would be cm3 (centimeter cubed)

VOLUME (IRREGULAR SOLID)

• First get graduated cylinder to find the water displacement
• Next you add the water into the graduated cylinder to the measurement you like
• After that, carefully slide your object into the cylinder so the water does'nt splash
• Finally, find the differnce of the two measurements to get your irregular volume

MASS

• To find mass, use a triple beam balance
• First, make sure the pointer is at the zero line
• Then carefully place the obeject you are measuring onto the pan
• Then, going from greatest to least, move the riders forward until the pointer is at the zero line
• Finally, add all of the riders to get your mass (there will most comonly be a decimal)

DENSITY

• To get the density you must use an equation
• The equation is mass/volume = density
• (M/V=D)

THE END