TOOL PROJECT

DAY 1

• Bought needed materials (1 hour)
• Soaked wood all day
• Dried/shaped over night

DAY 2

• Shaped wood placed on 3 and a 1/2 by 4 and 1/2 piece of wood.
• Traced and cut out for the base
• Punctured with drill and twined with copper wire
• The metal trim was leather twined (45 minutes)

Untitled Slide

DAY 2 CONTINUED

• Wheels traced and cut. Took out pieces to make spokes. (Cut with razor knife) (40 minutes)
• Filed down with nail file and placed on axel (15 minutes)

DAY 3

• Axel cut smaller and filed down with nail file (few minutes)
• Soaked wood in room temperature water to make the D-Frame by bending it (supports the chariot) (around an hour)
• It was then tied with copper wire
• Wheels where then coated with charcoal sticks and iron trim drilled on chariot. (around 15 minutes)

Untitled Slide

DAY 4

• D-frame fastened onto axel by twining
• Chariot fastened to D-frame by twining as well (both took about an hour and a half)
• Crushed a pomegranate, making the paint. Used paint brush to coat. (Added numerous coat and took a few hours)

Untitled Slide

DAY 5

• Final touch ups/check
• Yoke was then soaked and bent, attached to the bottom with twine (soaked the night before and then secured shape over the day/night)

THE END